The final sealing of the fuselage, tip tanks and horizontal stabilizer has been completed and they were prepared to be shipped off to have their external paint removed. All openings, seams, windshield and windows had aluminum tape or sealer applied to keep the chemical stripper out of the inside. The tip tanks and horizontal stabilizer were loaded onto a trailer on August 5, 2025 and taken to a paint facility for paint stripping using Al Goodwin’s truck and a trailer borrowed by Dave Dendurant. The tip tank cradles were the same ones that were used for their trip from Florida. The fuselage was lifted off of its jacks and placed in its cradle on a trailer for its trip to have the paint stripped on August 12, 2025. The truck and trailer, as well as the trip to the paint facility, were donated by Patton Trucking of Clearwater, Kansas. These parts should be back in building 14 in early September and ready to have the remaining bits of paint removed. Then we will remove the windshields, windows, panels, finish the internal foam removal and start the Non-Destructive Inspection (NDI). Any issues found on the skins, stringers, etc., such as corrosion, will be repaired or replaced. While these parts are out to be stripped, we are currently setting up to do a pressure check of the right hand wing looking for any leaks. These results, along with the corrosion found on the left wing, will help us make a decision about the wing. Whether it is repairable or we must replace it. Cross your fingers! We just passed 1,400 volunteer hours since 23-003 arrived in Wichita! Thank you to all of you who have contributed your time to help restore 23-003!

We are prepping the fuselage, tip tanks and horizontal stabilizer for transport to a paint facility for paint stripping. The keel beam and doors have been reinstalled to prevent the fuselage from twisting or bending during lifting and transport. The parts room has been set up and we now have a couple of volunteers that are developing the inventory control system and ordering parts. When the airplane comes back from paint strip, we will remove the windows, finish the internal foam removal and get the Non-Destructive Inspection (NDI) started. We will then start repairing or removing any corrosion that is found on the skins and structure. Also, we are looking into a potential repair of the discovered wing corrosion. We will also get the wing leading edges cleaned up and inspected for any excessive corrosion. Will you volunteer? We need your help with the restoration of 23-003! Help in all areas! A&P’s, electricians and all people willing to assist others, move stuff around, hand a screwdriver to a mechanic, fill out forms and paperwork, push a broom or just provide enthusiastic support to others! We can use your expertise, whatever and however you can help! Schedules are flexible to your availability! You don’t have to be a former or current Learjet employee to volunteer! Direct questions and to volunteer please contact our volunteer coordinator, Brenda Parks, through her email: Brenda.Parks@ClassicLear.org